Reply
Advisor
Tarner
Posts: 442
Registered: ‎12-18-2009
0
Accepted Solution

Geometry not closing????

What am I doing wrong here.  I'm drawing up some cabinet doors and detailing them out.  I made a box to represent the rail.  Then I drew the profile for the ends extruded them threw the rail and used the intersect selected and deleted the unwanted objects.  Then I drew the profile that runs along the length and extruded, intersect selected and deleted unwanted objects.  But the faces the make up the profile along the length won't turn white like the rest of the component they stay blue.  Why does it do this?  It's just on this profile.  The two end profiles came out fine.

 

 

woodq.jpg

Veteran Advisor
georgenoeth1
Posts: 651
Registered: ‎10-20-2009
0

Re: Geometry not closing????

Select the part, Try right clicking on the part then seleting reverse faces.

George Noeth (Gadget Guy)
Wood Online forum Host
Advisor
Tarner
Posts: 442
Registered: ‎12-18-2009
0

Re: Geometry not closing????

Awesome, that did the trick.  Thanks for the help Geaorge!!

 

© Copyright 2009, Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.