Reply
Frequent Contributor
Wisconsin Bob
Posts: 39
Registered: 10-28-2009
0

Re: A "question"

Use fluorescents...

Wisconsin Bob
Advisor
Gary K.
Posts: 758
Registered: 10-25-2009
0

Re: A "question"

Well, I would say that it would take four.  One to change the bulb....and three to sit around drinking coffee and talking about how much they miss the old bulb. :smileytongue:

******************************************************************
" Anyone who isn't confused here, doesn't really know what's going on."





Advisor
ynoT
Posts: 1,445
Registered: 10-23-2009
0

Re: A "question"

And the pilgrim has spoken....

Senior Contributor
Ted in Michigan
Posts: 194
Registered: 10-23-2009
0

Re: A "question"

Unless the bulb was made in China.............

Ted in Michigan
Go Buckeyes!
Advisor
whitedogstr8leg
Posts: 463
Registered: 10-23-2009
0

Re: A "question"

There might even be one the will say " Should be nailed in, not screwed".    One will also ask what is the "finish schedule used" ( simple, just flip a switch) and then tell you that you've used "marketing hype" to buy the bulb.

  BTW, it CAN be two to screw in a light bulb, but only if the bulb is very large.

smarter than a doorknob, meaner than concrete
Frequent Contributor
ColoEd
Posts: 36
Registered: 10-23-2009
0

Re: A "question"

WB Pilgrim.  It has been a while.

Ed

Try not to become a man of success, but rather to become a man of value. Albert Einstein
Advisor
Gary K.
Posts: 758
Registered: 10-25-2009
0

Re: A "question"

 


ColoEd wrote:

WB Pilgrim.  It has been a while.


 

Thank you Ed.  Feels mighty fine to be back in the saddle.:smileywink:

 

******************************************************************
" Anyone who isn't confused here, doesn't really know what's going on."





 

© Copyright 2009, Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.