Reply
Senior Reader
DMEdwards501
Posts: 2
Registered: ‎11-16-2010
0

3d end grain cutting board

i cut pieces of map-cher-walnut to 60 degree on my old ridged table saw ( which i sq up to best i could ) 16 in long-glued and clamped-theyre real close- but not enough- wondering if anyone could tell me how to get them plumb

Honored Advisor
RussBoyd
Posts: 7,908
Registered: ‎10-23-2009
0

Re: 3d end grain cutting board

Just a bump up to the top. (I want to know too)

"If you can't hide it...advertise it!"

 

© Copyright 2009, Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.